NECHVILLE
WARP DRIVE
FOR HELI-MOUNT
BANJOS
Dual Source
Professional
Pickup System
Quick Start Guide
Installation
You will need:
• Phillips screwdriver
• 1/8” Allen wrench
• 13mm socket wrench
Check the two bolts that hold
the EMG pickup as they
might require re-tightening
from transit. The EMG
should be parallel to the Warp
Drive body.
Mount the jack bracket on the
frame by removing the two
1/8” Allen bolts and
sandwiching the bracket on
either side of the frame as
shown.
Optimal position shown here
Unscrew the tip, washer,
and threaded nut. Slide
the jack through the
mounting bracket and
replace hardware. Replace
the washer and tighten the
13mm threaded nut with
a ratchet then replace the
tip.
Slide the wire terminal
through a slotted window
in the frame so that it
won’t interfere with the
resonator.