Necta Vending Solutions SpA StarFood Installation, Use And Maintenance Manual Download

Page: 13 / 68

0401 171 - 02

Chapter 2

INSTALLATION

Installation and the following maintenance operations
should be carried out with the machine switched on and
therefore by qualified personnel only, who are trained in the
correct use of the machine and informed about the specific
risks of such situation.

The machine is not suitable for outdoor installation, it
must be installed in a dry room where the temperature
remains between 5°C and 32°C.

It cannot be positioned where water jets are used for
cleaning (e.g. in large kitchens, etc.).

The machine should be positioned with a maximum
inclination of 2°.

UNPACKING THE VENDING MACHINE

After removing the packing, ensure that the machine is
intact.
If the vending machine is found to be damaged, immedi-
ately inform the carrier and do not use the machine.

No packing elements (i.e. plastic bags, polystyrene
foam, nails, etc.) should be left within the reach of
children, as they are potentially dangerous.

Packing materials must be disposed of in authorised
containers and the recyclable ones must be recovered by
qualified companies.

CONNECTING THE MACHINE TO THE
POWER SUPPLY

The machine is designed to operate under single-phase
230 V~ voltage and is protected by 15 A fuses.
Before making the connection, ensure that the rating
corresponds to that of the power grid, and more specifi-
cally:

- the supply voltage rating must be within the range

recommended for the connection points;

- the main switch should be capable of withstanding the

peak load required, and at the same time ensure
proper omnipolar disconnection from the power grid
with an opening gap of the contacts of at least 3 mm.

The switch, the power outlet and the plug must be
located in an easily accessible position.

The electrical safety of the machine is ensured only when
it is correctly earthed according to the safety standards in
force.

This fundamental safety requirement must be duly
verified, and if in doubt the system must be carefully
tested by qualified technicians.

The power supply cable is of the type with a fixed plug. Any
replacement of the power cable (see figure) should be
made by qualified and suitably trained personnel only using
cables type HO5 RN - F or HO5 V V-F or H07 RN-F with a
3x1-1.5 mm

section.

Fig. 7

1 - Power supply cable
2 - Cable clamp
3 - Lift cover

Do not use adapters, multiple sockets and/or exten-
sions.

THE MANUFACTURER DECLINES ALL RESPONSI-
BILITY FOR ANY DAMAGE CAUSED BY NONCOMPLI-
ANCE WITH THE ABOVE MENTIONED PRECAUTIONS.

INSTALLING THE PAYMENT SYSTEM

The machine is sold without payment system, there-
fore the installer of such a system is responsible for
any damage to the machine or to things and persons
caused by faulty installation.

- Install the desired coin mechanism according to the

appropriate instructions and make sure that the rel-
evant parameters are programmed correctly.

- adjust the selector opening lever bracket to allow

complete opening of the selector;

- adjust the coin chute according to the type of coin

mechanism installed.