vii)
Dispose of the old glass in a responsible manner.
This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
i)
Remove any old seal from the door.
ii)
Clean out the groove in the door that the seal was
bedded in using a flat-end screw driver or equivalent.
iii)
Run a thin bead of clear roof and gutter silicone
along the groove.
iv)
Starting at one end, press the new door seal into the
groove on the door.
v)
Refit the door if it has been removed and close.
Over time, the door seal can become compressed resulting in
a less than adequate seal between the door and the front
edge of the firebox. For example, if the wood burns unusually
fast even with the air slide shut, it may mean that there is an
air leak around the door.
In this situation, the door seal does not necessarily need
replacing rather adjustment of the door handle can tighten
the seal.
There are two ways to tighten the door:-
i)
Adjust door latch rod
– the rod on the right side of the
firebox upon which the door handle latches onto can be
gently tapped with a hammer. The rod only needs to be
moved 1mm or less, which is a very gently tap. Too
much and the rod will need to be levered out again.
Close the door to test if any improvement in the door
closing firmly.
ii)
Remove washer from door handle assembly
–
a.
Remove the nut from the door handle shaft inside
the door.
b.
Remove the T-shaped latch and remove one
washer.
c.
Replace the latch and then place the remove
washer over the rod.
d.
Refit the nut. Do not over tighten otherwise door
handle will not turn easily.
If door seal is still not tight enough remove another washer
or replace door seal.
1. Firebricks
500 Series
6 @ 235mm x 175mm x 25mm
1 @ 235mm x 140mm x 25mm
3 @ 235mm x 85mm x 25mm
800 Series
10 @ 285mm x 175mm x 25mm
2. Baffle Plate
500 Series 490mm x 230mm x 8mm (10kg)
800 Series 590mm x 286mm x 8mm (14kg)
3. Ash Deflector
500 Series 495mm x 130mm x 5mm
800 Series 595mm x 130mm x 5mm
4. Door Seal
500 Series 1300mm x 16mm round
800 Series 1900mm x 16mm round
5. Glass Seal
500 Series 1550mm x 19mm x 3mm flat adhesive back
800 Series 1840mm x 19mm x 3mm flat adhesive back
6. Brick Retainer Brackets
500 Series 2 x corner brick retainers
4 x flat brick retainers
800 Series 2 x corner brick retainers
4 x flat brick retainers
7. Door Glass
500 Series 483mm x 253mm x 5mm pyroceramic
800 Series 583mm x 303mm x 5mm pyroceramic
6. FITTING A NEW DOOR SEAL
7. DOOR HANDLE ADJUSTMENT
8. REPLACEMENT SPARE PARTS LIST
