8
GENERAL OPERATION
Once the heater has been burning on high for approximately 20 to 30 minutes it
will have reached operating temperature. You may now slow the burn down by
adjusting the air slide into the closed position. Turn the fan on to the preferred
speed setting.
When adding wood, open the air slide fully, wait a few seconds, then open the
door slowly. After re-loading, leave air slide open, on high for 15 - 20 mins to
allow new fuel to catch freely and entirely.
Then re-adjust the air slide to desired setting for maximum efficiency. If the fire
is too small, refuelling first with kindling is advised.
OVERNIGHT BURN
An overnight burn can be achieved by following these steps an hour before
retiring:
1) Open air slide fully
2) Load with large pieces of dry wood
3) When all wood is burning, slowly move the air slide to low position.
4) Turn fan to OFF position.
NOTE: This procedure can be done at any time, for example, in the morning so
that the fire is still going later that day.
