8
Flue Requirements
Install a 150mm diameter double cased flue kit to comply with AS 2918. Fit an
additional 300 mm diameter outer casing from the heater to a minimum of 300
mm above the ceiling having bent tabs or spacers to ensure a 25 mm clearance
to the flue outer is maintained. A hole of 350 mm diameter is required in the
ceiling and a 25 mm clearance between any combustible material and the 300
mm outer casing. Refer to diagram below.
Fit the outer trim using the four 4mm screws. This is best achieved with the door
open.
The fire is now ready to use. Note the first few firings will cure the paint. Keep the
room well ventilated whilst this is happening as fumes are given off.
Summary of Contents for FS 800
Page 10: ...10 ...
