9
5.
INSTALLING THE FIREBOX
INTERNALS
1)
Open spark arrestor and remove the box of bricks, grate
and damper handle from inside the fireplace.
2)
Bricks are placed in the retainer in a vertical orientation.
Angle top edge of the brick towards the back of the
firebox and slot under the retainer, allowing the bottom
of the brick to sit on the horizontal lower shelf.
3)
With the bricks installed, place the toothed grate lip in
the front of the firebox with the Nectre logo on the left
side facing out. Place the left and right halves of the grate
into the fireplace with the front and rear edges resting on
the grate lip and rear shelf respectively.
4)
Slide the ash tray in underneath the grate lip, pushed
back as far as it will go, close the spark arrestor.
