INCLUDED MATERIALS
1 x MACE Smart reader
1 x Installation manual
1 x Plastic bag including:
o
1 x Connector block 6P
o
1 x Connector block 7P
o
2 x Assembly screw M3x8 T10 (1x spare part)
o
2 x Plug Nylon
o
2 x Mounting screw K30x20 T10
ADDITIONAL REQUIREMENTS
Drill
Screwdriver torx T10
Pliers (optionally)
RS485-USB converter (optionally)
Cable AWG 22-30 shielded (advised)
SAFETY INSTRUCTIONS
The following safety precautions should be observed during normal use, service and repair:
The MACE Smart reader may only be installed and serviced by qualified service personnel.
Disconnect the power supply before (dis)connecting any wires, MACE is NOT hot-
swappable, so when making or changing connections, power must be switched OFF.
The cable shield shall be connected with safety ground and the metal case of the external
device(s).
To be sure of safety, do not modify or add anything to the MACE Smart reader other than
mentioned in this installation guide or indicated by NEDAP N.V.
CONFIGURATION
The MACE Smart reader can be configured easily using the MaceConfigTool software. This
software tool can be downloaded from our partner portal
https://portal.nedapidentification.com
.
Configuration allows to change general settings, reader settings (what to read and how) and
communication output settings. It also allows updating or changing the firmware (e.g. STANDARD
and OSDP). When your computer does not have an RS485 output, an RS485-USB converter can be
used to connect with the MACE Smart reader.
Some settings require expert knowledge. Leave settings unchanged, when their specific meaning
is unclear. Besides, it is always a good practice to save the configuration into a file for future
reference or when requesting technical assistance from Nedap or its business partners.
10
0
mm
( 3.94
)
50 mm
( 1.97
)
3.4 mm
( 0.13
)
5
.4
m
m
( 0
.2
1
)
20 mm
( 0.79
)
3
0
m
m
( 1
.1
8
)
6
0
m
m
( 2
.3
6
)
1
9
.5
m
m
( 0
.7
7
)
2
5
.0
m
m
( 0
.9
8
)
MACE SMART
Installation sheet
2018-01-25 | v1.02 | 5286573
