Magna Track LS
11
EN
4
Description
4.1
Intended use
Magna Track LS is intended for the extraction of exhaust fumes from vehicle
combustion engines in applications with low frequency use, low speed and
limited airflow, see Section
4.2. Technical data.
4.2
Technical data
Table 4-1: Technical data
Mounting height
3.3–3.6 m (11–12 ft)
User speed
5 km/h (3 mph)
Pressure drop at 400 m
3
/h (250 cfm)
300 Pa (1.2 in wg)
Pressure drop at 1000 m
3
/h (600 cfm) 1550 Pa (6.2 in wg)
Hose diameter
125 mm (5”)
Material, hose upper
EPDM/PP coated fabric (thermoplastic) 205 °C (400 °F)
Material, hose lower
Clip hose 315 °C (600 °F)
Material, nozzle hose
Neoprene rubber hose 150 °C (300 °F)
Material, track
Aluminum
5
Before installation
5.1
Delivery checks
Check the unit for any transport damage. In case of damage or parts missing,
notify the carrier and your local Nederman representative immediately.
5.2
Installation requirements
Before Magna Track LS can be installed, a suitable position must be
determined in relation to the vehicle’s parking position in the station. See
Figure 1.
The distance from the floor to the bottom edge of the track is normally to be
3.3–3.6 m (11–12 ft). The track is to be installed at least 0.3 m (1 ft) from the
side of the threshold. If Magna Track LS is to be used between two vehicles,
the distance between the vehicles must be at least 2 m (6 ft).
The distance from the track’s leading edge to the station door is to be at least
1.5 m (5 ft). Make sure the door can open freely without interference to the
track.
