MagnaTrack S
CS
• V případě potřeby zkontrolujte směr otáčení
oběžného kola ventilátoru a/nebo funkci klapky.
6
Zkontrolujte elektrickou instalaci (odpojovací
skříň, mikrospínač, magnet) podle schématu zapo-
jení.
4.10 Ventilátory
Ventilátory nejsou součástí základního balení. Pro do-
sažení nejlepších výsledků se doporučuje jeden venti-
látor na odsávací jednotku. Je také možné připojit ně-
kolik jednotek k centrálnímu ventilátoru.
Za účelem získání podtlaku v systému odsávání a vy-
varování se úniku zplodin musí být ventilátor umístěn
co nejblíže prostupu potrubí ven z budovy.
Ohledně výběru ventilátoru kontaktujte svého zá-
stupce společnosti Nederman .
POZNÁMKA!
Pro elektrický systém včetně ventilátoru se do-
poručuje uzamykatelný bezpečnostní spínač.
4.10.1 Doporučené tlakové ztráty a proudě-
ní vzduchu
• 800 Pa + 45 Pa/m kolejnice na 1000 m3/h (3.2 in.wg
+ 0.055 in.wg/ft) dráze při 600 cfm (6" hubice).
• 800 Pa + 30 Pa/m kolejnice na 600 m3/h (3.2 in.wg
+ 0.037 in.wg/ft) dráze při 400 cfm (5" hubice).
5 Použití
VAROVÁNÍ! Riziko poranění osob.
• Systém musí být používán pouze v kombinaci
s kotevní destičkou, která musí být připevně-
na na vozidle.
• Neodsávejte horký, hořící nebo zapálený ma-
teriál nebo látky, které mohou reagovat s díly
nebo materiály systému odsávání.
• Systém nesmí být používán při práci na pali-
vovém systému vozidla nebo když existuje
nebezpečí z důvodu přítomnosti hořlavého
prachu nebo výbušných plynů.
• Systém musí být při mytí vozidla odpojen a
nesmí být vystaven působení vody.
• Systém je určen k použití pouze ve směru dél-
ky kolejnice.
• Systém nesmí být používán k jiným účelům,
než je odsávání zplodin.
• Zkontrolujte, že v odsávací hadici je dostateč-
ná kapacita sání, než ji připojíte k výfuku vozi-
dla. V případě potřeby zkontrolujte směr otá-
čení oběžného kola ventilátoru a/nebo funkci
klapky.
• Zkontrolujte, že hubice je správně uchycena
k výfuku poté, co jste s vozidlem pohybovali.
• Při práci s motorem v chodu a obzvláště v ma-
zací dutině se doporučuje použití výstražné-
ho zařízení proti přítomnosti plynu.
• Oprava poškozených kabelů nebo jiných elek-
trických součástí by měla být provedena kva-
lifikovaným elektrikářem. Pokud je napájecí
kabel poškozen, vyměňte jej pouze za kabel
stejného typu.
• Pružná hadice odolá 150 °C (300 °F) při ne-
přetržitém chodu i 180 °C (355 °F) po krátkou
dobu. Použití při vyšších teplotách zkrátí ži-
votnost výrobku. Proto se vyhněte úkolům,
které vyžadují delší dobu nepřetržitého cho-
du, což vede k vysokým teplotám výfukových
plynů.
5.1 Připojení
POZNÁMKA!
Hadice by měla být vždy připojena k výfukové-
mu potrubí, když je vozidlo zaparkováno ve sta-
nici.
1
Otevřete dvířka stanice a spusťte odsávací venti-
látor (nebo lze ventilátor připojit k automatickému
systému start/stop).
2
Nacouvejte vozidlem tak, aby byl výfuk ve dveřích
stanice, viz
.
3
Umístěte odsávací hubici k výfuku. Upevněte elek-
tromagnetickou jednotku na kotevní destičku
umístěnou na boku vozidla, viz
30
Summary of Contents for MagnaTrack S
