Nederman SYSTEM 920, User Manual

Rail System 920 Touchless

EN

1 Preface

Thank you for using a Nederman product!
The Nederman Group is a world-leading supplier and

developer of products and solutions for the environ-

mental technology sector. Our innovative products

will filter, clean and recycle in the most demanding of

environments. Nederman's products and solutions will

help you improve your productivity, reduce costs and

also reduce the impact on the environment from in-

dustrial processes.
Read all product documentation and the product iden-

tification plate carefully before installation, use, and

service of this product. Replace documentation imme-

diately if lost. Nederman reserves the right, without

previous notice, to modify and improve its products

including documentation.
This product is designed to meet the requirements

of relevant EC directives. To maintain this status, all

installation, maintenance, and repair is to be done

by qualified personnel using only Nederman original

spare parts and accessories. Contact the nearest au-

thorized distributor or Nederman for advice on tech-

nical service and obtaining spare parts. If there are

any damaged or missing parts when the product is de-

livered, notify the carrier and the local Nederman rep-

resentative immediately.

2 Safety

2.1 Classification of important informa-

tion

This document contains important information that

is presented either as a warning, caution or note, ac-

cording to the following examples:

WARNING! Risk of personal injury

Warnings indicate a potential hazard to the

health and safety of personnel, and how that

hazard may be avoided.

CAUTION! Risk of equipment damage

Cautions indicate a potential hazard to the

product but not to personnel, and how that

hazard may be avoided.

Notes contain other information that is import-

ant for personnel.

2.2 General safety instructions

WARNING! Risk of personal injury

• The system must not be used for other pur-

poses than extracting fumes.

• The system is designed for use only with sta-

tionary vehicles. The vehicle must not be

moved when the nozzle has been placed next

to the vehicle exhaust pipe.

• This product is designed for extracting fumes

from an idling vehicle. 

Not

 for continuous

high rpm testing! See allowed exhaust tem-

peratures in 

Section 3.2 Technical data

.

• The system must not be used when working

on the vehicle´s fuel system, when rechar-

ging the batteries or whenever there is a risk

for inflammable dust or explosive gases.

• When working with a running engine and es-

pecially in a maintenance pit a gas detector is

recommended.

• Check that there is enough suction capacity

in the extraction unit before it is connected

to the vehicle’s exhaust pipe. If not, check the

fan impeller rotation direction and/or damper

function. If necessary check the installation

of the fan start switch.

• There is a risk of heat injuries since the tele-

scopic arm and the pin-jointed arm get hot

during high load. In such cases avoid touching

the pipe.

10