X-Liner 360 2 green
OPERATING INSTRUCTIONS
13
5 Power Supply
EN
When starting up the
X-Liner 360 2 green
for the first time, install the batteries (4) supplied, as
shown in the battery compartment.
Insert /replace batteries
Operation of the
X-Liner 360 2 green
requires
4 batteries 1.5 V (AA).
• Lever open the locking clip of the battery
compartment cover and fold it out.
• Insert/replace batteries as specified.
Ensure pole direction is correct!
• Re-close the battery compartment cover and
press on until the locking clip latches back into
position.
If the batteries’ charge is weak, the laser
beams begin
to flash.
The laser switches off if the batteries
are too weak.
6 Operation
6.1 Starting up the unit
• Set up or fix the unit according to the intended use. Ensure the levelling
range of ±3° is not exceeded.
• If using the tripod, level the unit roughly using the adjustable unit feet
(3). The setting can be checked using the circular bubble (5). The
X-Liner 360 2 green
is correctly levelled if the air bubble is located in
the middle of the circle.
• Lock the pendulum locking device for use
without self-levelling
. To do
this, push the
unit switch into position 1
and use the
ON/OFF
button to switch on the unit. The laser lines flash slowly (every 4
seconds).
• Release the pendulum locking device for use
with self-levelling
. To do
this, push the
unit switch into position 2
and use the
ON/OFF
button to switch on the unit. If the laser lines flash quickly the
X-Liner 360 2 green
is outside the self-levelling range. The laser must
then be moved to within its levelling range.
• If you have finished working with the unit, lock the pendulum locking
device and use the
ON/OFF
button (press for 3 secs.) to switch off the
unit.
Alignment of the
circular bubble
Wrong
Correct
1
2
