NEFF B12S53.3GB, Instruction Manual

21

Cleaning

Clean the door panel with glass cleaner and a soft cloth.

: 

Risk of injury!

Scratched glass in the appliance door may develop into a 
crack. Do not use a glass scraper, sharp or abrasive cleaning 
aids or detergents.

Fitting the intermediate panel
Note: 

During installation, make sure that the lettering "top right" 

is upside down at the bottom left.
Insert the intermediate panel towards the back as far as it will 

go.

Fitting the door panel

1.

Insert the door panel at an angle towards the back into both 

brackets as far as it will go. The smooth surface must face 

outwards.

2.

Put the cover back in place and press on it until it clicks in 

place. 

3.

Refit the appliance door.

Cleaning the hook-in racks

You can remove the hook-in racks with telescopic shelves for 

easier cleaning.

: 

Risk of burning due to hot components in the cooking 

compartment!

Wait until the cooking compartment has cooled down.

1.

Push the hook-in rack upwards at the front and unhook to the 

side (figure A).

2.

Push the hook-in rack forwards at the rear and unhook to the 

side (figure B).

3.

Clean the hook-in rack with washing-up liquid and a sponge 

or brush.

4.

Align the hook-in rack with the indentation (a) facing 

downwards, so that the shelf heights match

5.

Insert the hook-in rack at the rear to the limit stop and push to 

the rear (figure C).

6.

Insert the hook-in rack at the front to the limit stop and push 

downwards (figure D).

7.

Push telescopic shelves in as far as the limit stop and close 

appliance door.

Faults and repairs

It is not always necessary to call the after-sales service. 

Sometimes, you can find a remedy yourself. You will find some 

tips for troubleshooting in the following table.

: 

Risk of electric shock!

■

Work on the appliance electronics may only be performed by 
a specialist.

■

Always disconnect the appliance from the power supply 

when work is carried out on the electronics. Switch off the 

circuit breaker or remove the fuse from your household fuse 

box.

$

%

D

D

&

'

Problem

Possible cause

Remedial action

Electrical function is faulty (e. g. indicator 

lamps do not light up)

Circuit-breaker faulty

Check circuit-breakers in the fuse box and 

replace if necessary

Liquid or thin dough runs to one side

Appliance not installed level

Check the appliance installation (see the 

Installation instructions)

‹

:

‹‹

 flashes in the clock display

There was a power cut

Reset the clock (see section: Electronic 

clock)

Electronically controlled functions are mal-

functioning

Energy surges (e.g. lightning strike)

Reset the function concerned