30
For the installer and kitchen
expert!
Important installation notes:
❑
Properly dispose of
packaging
materials.
❑
Do not use
oven door handle
for trans-
porting or handling the unit during
installation.
❑
WARNING:
Connection and first start of
the appliance may only be performed by
an authorised specialist.
❑
Connection must be made using an
H 0 5 V V- F mains connection cable.
❑
Nominal connected loading, nominal
voltage and model number of the
appliance:
see the rating plate, located behind the
oven door, fixed to the lower left facing
edge of the oven.
❑
The unit's nameplate is located at on
the right sidewall of the unit.
❑
Electrical safety
of the appliance can
be ensured only if the equipment earth
in the building installation has been
installed according to regulations.
❑
On the installation side a isolating device
shall be provided.
Any switch with a contact gap ex-
ceeding 3 mm may be considered
a separating device.
Other examples are LS switches, fuses
and contactors.
❑
In the case of repairs
interrupt all
power connections to the unit.
❑
Connection diagram
Kitchen furniture
Oven housing units from virtually all lines of
kitchen furniture are suitable for installing
the built-in oven. However, the veneers or
plastic laminates on the housing unit must
be applied with heat-resistant glue (90 °C).
If plastic laminate or glue are not sufficiently
heat-resistant, warping, bubbling or
detachment of the finish may result.
220-240V
~
L
N
Assembly Instructions