Cleaning function
en
33
Preparation
:
Warning
Risk of fire!
■
Loose food residues, grease and meat juices may
catch fire during the cleaning function. Before
starting the cleaning function, remove coarse dirt
from the cooking compartment and from the
accessories.
Risk of fire!
■
The appliance will become very hot on the outside
during the cleaning function. Never hang
combustible objects, e.g. tea towels, on the door
handle. Do not place anything against the front of
the appliance. Keep children away from the
appliance.
Risk of fire!
■
If the door seal is damaged, a large amount of heat
will be generated around the door. Do not scrub or
remove the seal. Never operate the appliance if the
seal is damaged or missing.
:
Warning – Risk of serious damage to health!
The appliance will become very hot during the cleaning
function. The non-stick coating on baking trays and tins
is destroyed and noxious gases are released. Never
clean non-stick baking trays and baking tins using the
cleaning function. Only clean enamelled accessories
using the cleaning function.
Caution!
Shelf supports and pull-out rails tend to discolour if they
are left in the cooking compartment when it is cleaned.
Before you start the cleaning function, remove the shelf
supports and pull-out rails from the cooking
compartment.
1.
Remove the shelf supports and pull-out rails from the
cooking compartment.
2.
Remove the water reservoir.
Caution!
Before you start the cleaning function, remove the
water reservoir from the appliance.
3.
Remove the worst of the food residues from the
cooking compartment and accessories.
4.
Clean the inside of the appliance door and along the
edges of the cooking compartment in the area
around the seal. Do not scrub the seal.
5.
Insert the accessory supports if you wish to clean
accessories when the cooking compartment is being
cleaned. Make sure that the vertical bar
‚
on the
accessory support is facing the front (figure
!
).
6.
Insert the rear end of the accessory support as far
as it will go into the rear socket
ƒ
, and push the
accessory support back
„
(figure
"
).
7.
Then insert the front end of the accessory support as
far as it will go into the front socket
…
, and push the
accessory support down
†
(figure
#
).
8.
Whenever you wish to use the cleaning function,
make sure that you never leave anything other than
an enamelled accessory without anti-stick coating
(e.g. the universal pan) on the accessory supports
(figure
$
).
Caution!
The wire rack tends to discolour if it is left in the
cooking compartment when it is cleaned.Do not
attempt to clean the rack using the cleaning function.
Note:
Further accessories that can be cleaned using
the cleaning function are listed in the table for
Starting
1.
Touch the
#
touch button.
2.
Touch the
0
touch button.
3.
Swipe to the left or right to select "Pyrolytic self-
cleaning
˜
".
4.
Touch the bottom line.
5.
Swipe to the left or right to select the cleaning level.
Note:
Once cleaning starts, the cleaning level can
no longer be changed.
6.
Touch the bottom line.
7.
Touch the
#
touch button.
The appliance starts the self-cleaning programme.
Ventilate the kitchen when the cleaning function is
running.
During self-cleaning, the appliance door is automatically
locked. The
5
symbol appears on the display.
Note:
If you would like to start self-cleaning later, set an
end time.
D
D
1
G
H
E
F
2
Summary of Contents for B58VT68H0
