Appliance door
en
23
Note:
Further information:
19.4 Attaching the pull-out rail
Note:
The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
Guide the pull-out rail with the rear retainer from
below behind the two guide rods for the required
shelf position and keep it horizontal.
2.
Guide the rail lengthways to the rear to the guide
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer to grip the ver-
tical rod.
3.
Press and hold
PUSH
and swing the pull-out rail
inwards until the retainer is attached in the
lower rod.
a
4.
Release the
PUSH
tab.
a
The retainer clicks into place.
5.
Pull the pull-out rail out as far as it will go and slide
it back in.
Note:
Further information:
20 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
WARNING ‒ Risk of injury!
If the hinges are not secured due to an incomplete
lock, they can snap shut with great force.
▶
To detach or attach the appliance door, always turn
the two locks as far as they will go.
▶
If the hinge snaps closed when detaching or attach-
ing the appliance door, do not reach into the hinge
– call the after-sales service.
Note:
Further information:
Summary of Contents for B59CR3A 0 Series
Page 1: ...Oven User manual and installation instructions B59CR3A 0...
Page 42: ......
Page 43: ......
