38
Neff
C1.KS61N0 | 07/2014
en
Initial use
General
Fill the appropriate container using only
pure,
cold
, uncarbonated water and solely
roasted
beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines)� Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit�
A
Before the appliance can be
switched on and used, it must
be assembled and connected
according to the enclosed assembly
instructions�
Setting up the appliance
● Remove any protective plastic film.
F
Important:
Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
● Take hold of the appliance door by the
recessed grip and open�
● Remove the water tank, rinse it and fill it
with fresh water up to the “max�” mark�
● Replace the water tank and click into
place�
● Remove the bean container, fill with
coffee beans and replace�
● Set the mains switch to
I
and close
the appliance door�
The appliance heats up and is rinsed�
The display is activated�
“Please set your preferred language.”
appears�
● Press the
M
arrow button. The field
“Deutsch”
has a light background� The
language can be changed�
● With the
L
arrow button select the
desired language�
● Press the
N
arrow button. The field
“Language”
has a light background�
● Select the
“Water hardness”
with the
L
arrow button�
F
It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run�
The preset water hardness is level
4�If a water softener is installed in
the house, please set the water hard-
ness to level 3� You can also check
the water hardness by asking your
local water supplier�
● Use the enclosed test strip to determine
the water hardness. Briefly dip the test
strip in water and check the result after
one minute�
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
● Press the
M
arrow button. The field
“4 (very hard)”
has a light background�
The water hardness can be changed�
● Set the water hardness determined with
the
K
arrow button�
● Press the
M
arrow button�
“Complete set-up?”
appears�
● Press the
M
arrow button� The settings
are saved�
The appliance is ready to use when the
drink symbols are shown on the display�
The integrated fan switches on each time
a drink is dispensed and switches off again
after a few minutes�
