Appliance door
en
21
Inserting the holders
If the holders fall out when you remove the rails, these
must be re-inserted.
1.
The holders at the front differ from those at the rear
(fig.
!
).
2.
Use the hook to mount the front holder at the top
into the round hole
‚
, set it at a slight incline, attach
it at the bottom, and straighten it
ƒ
(fig.
"
).
3.
Use the hook to attach the rear holder into the upper
hole
‚
and push it into the lower hole
ƒ
(fig.
#
).
Attaching the rails
When hanging the rails, ensure that the sloping edge is
at the top of the rail.
The rails fit both the left and right sides.
1.
Hold the rear of the frame at an angle, and mount it
at the top and bottom
‚
(fig.
!
).
2.
Pull the rail forwards (fig.
"
).
3.
Then fold it forwards and insert it (fig.
#
)
4.
and push it downwards (fig.
$
).
q
Appliance door
Appliance door
With good care and cleaning, your appliance will retain
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.
Removing the door cover
The stainless-steel inlay in the door cover may become
discoloured. To carry out thorough cleaning, you can
remove the cover.
1.
Open the appliance door slightly.
2.
Press on the right and left side of the cover (fig.
!
).
3.
Remove the cover (fig.
"
).
Close the appliance door carefully
Note:
Clean the stainless-steel inlay in the cover with
a stainless-steel cleaning agent. Clean the rest of the
door cover with soapy water and a soft cloth.
4.
Open the appliance door again slightly. Put the
cover back in place and press on it until it clicks
audibly into place (fig.
#
).
5.
Close the appliance door.
D
E
2
1
D
E
2
D
D
1
2
1
Summary of Contents for C17MR02G0B
Page 1: ...en INSTRUCTION MANUAL BUILT IN OVEN C17MR02G0B...
Page 2: ......
Page 46: ...6...
Page 47: ......
