en
Installation instructions
22
17.1 Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡
The appliance can only be used safely if it
is correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly
at its installation location.
¡
Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡
Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡
Proceed in accordance with the installation
sheets for installing accessories.
¡
Fitted units must be temperature-resistant
up to 90 °C, and adjacent unit fronts up to
65 °C.
¡
Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡
Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡
Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
WARNING ‒ Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶
Wear protective gloves
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶
Do not use extension cables or multiple
socket strips.
▶
If the power cord is too short, contact Cus-
tomer Service.
▶
Only use adapters approved by the manu-
facturer.
17.2 Appliance dimensions
You will find the dimensions of the appliance here
17.3 Fitted units
This appliance is only intended to be fully fitted in a kit-
chen. It is not intended to be used as a tabletop appli-
ance or within a cupboard.
The fitted cabinet must not have a back panel behind
the appliance. Maintain a clearance of at least 35 mm
between the wall and the cabinet base or the rear
panel of the cabinet situated above.
The fitted cabinet must have a ventilation opening of
50 cm² on the front. To do this, trim the base panel or
fit a ventilation grille.
Surround units without a ventilation cut-out must have a
ventilation opening measuring 200 cm² towards the
rear of the side panels.
Ventilation slots and intake openings must not be
covered.
The mains socket for the appliance must either be loc-
ated in the hatched area or outside of the area
where the appliance is installed.
Any unsecured units must be secured to the wall using
a standard bracket .
17.4 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
WARNING ‒ Danger: Magnetism!
The appliance contains permanent magnets. These
may affect electronic implants, e.g. heart pacemakers
or insulin pumps.
▶
Persons with electronic implants must stay at least
10 cm away from the appliance.
Summary of Contents for C17UR02.0B
Page 1: ...Microwave Oven en User manual and installation instructions C17UR02 0B ...
Page 25: ......
Page 26: ......
Page 27: ......
