Cleaning function
en
21
Surfaces in the cooking compartment
The back wall, ceiling and side parts in the cooking
compartment are self-cleaning. You can tell this from
the rough surface.
The cooking compartment floor is enamelled and has
smooth surfaces.
Cleaning enamelled surfaces
Clean the smooth enamelled surfaces with a dish cloth
and hot soapy water or a vinegar solution. Then dry with
a soft cloth.
Soften baked-on food residues with a damp cloth and
soapy water. Use stainless steel wire wool or oven
cleaner to remove stubborn dirt.
Leave the cooking compartment open to dry after
cleaning.
Tip:
Using the cleaning aid gives the best results.
"Cleaning function" on page 21
Note:
Food residues can cause white deposits to form.
These are harmless and do not affect how the
appliance works. You can remove these residues using
lemon juice if required.
Cleaning self-cleaning surfaces
The self-cleaning surfaces are coated with a porous,
matte ceramic layer. This coating absorbs and dispels
splashes from baking and roasting while the appliance
is in operation.
If the self-cleaning surfaces no longer clean themselves
sufficiently and dark stains appear, they can be cleaned
using the cleaning function. To do this, refer to the
information in the relevant section.
Caution!
Do not use oven cleaner on self-cleaning surfaces. This
will damage the surfaces. If oven cleaner does get onto
these surfaces, dab it off immediately using water and a
sponge cloth. Do not rub the surface and do not use
abrasive cleaning aids.
Keeping the appliance clean
Always keep the appliance clean and remove dirt
immediately so that stubborn deposits of dirt do not
build up.
Tips
■
Clean the cooking compartment after each use. This
will ensure that dirt cannot be baked on.
■
Always remove flecks of limescale, grease, starch
and albumin (e.g. egg white) immediately.
■
Use the universal pan for baking very moist cakes.
■
Use suitable ovenware for roasting, e.g. a roasting
dish.
■
Where possible, use hot air. This type of heating
creates less dirt.
.
Cleaning function
Cleaning
function
Your appliance is equipped with EcoClean and the floor
cleaning aid. The self-cleaning surfaces in the cooking
compartment are cleaned with the "EcoClean" cleaning
function. Use the floor cleaning aid for intermediate
cleaning of the cooking compartment floor. Dirt is
softened beforehand using the floor cleaning aid. It can
then be removed more easily.
EcoClean
The self-cleaning surfaces in the cooking compartment
are cleaned with the "EcoClean" operating mode.
The self-cleaning surfaces (back panel, ceiling panel
and side panels) are coated with a porous, matt
ceramic material. This coating absorbs and breaks
down splashes from baking, roasting and grilling while
the oven is in operation. If the surfaces no longer clean
themselves adequately and dark patches appear, the
surfaces can be cleaned by the cleaning function.
Note:
The appliance records the number of times it is
used.The appliance indicates when it has reached a
point in time after which cleaning is recommended. The
recommendation is displayed until the cleaning function
has finished.
If you do not act on this recommendation, the self-
cleaning surfaces may become damaged.
If your appliance is already prematurely very dirty or if
you notice dark patches on the back panel, do not wait
until your appliance recommends cleaning to do so.
This is because the more often the appliance is
cleaned, the longer the self-cleaning surfaces will retain
their cleaning capability. You can clean your appliance
at any time as required using the cleaning function.
Prior to initiating the cleaning function
Remove shelves, rails, accessories and ovenware from
the cooking compartment.
Cleaning the cooking compartment floor and the
inside of the appliance door
Remove the worst dirt from the cooking compartment
floor, the inside of the appliance door and the interior
lighting. Otherwise, patches will appear that can no
longer be removed.
Caution!
Do not use oven cleaner on the self-cleaning surfaces.
This will damage the surfaces. If oven cleaner does
come into contact with these surfaces, dab it off
immediately with water and a sponge cloth. Please to
not rub or use any abrasive cleaning materials.
Starting
Before setting the cleaning function, ensure that you
have followed all instructions for preparation.
Cleaning takes 1 hour and 15 minutes. The duration
cannot be changed.
1.
Touch the
#
touch button.
2.
Touch the
0
touch button.
Summary of Contents for C18MT33N0B
Page 1: ...en INSTRUCTION MANUAL Built in oven C18MT33N0B...
Page 2: ......