22
If you encounter a problem
If an
J
or
ã
appears in the display:
❑
See "Filters and maintenance" Section.
If is not possible to operate the extractor
hood:
❑
Disconnect the extractor hood from the
mains electricity supply by pulling out the
plug or switching it off at the main fuse
box.
Wait for approx. 1 minute and then
switch it on again.
If you have any questions or if a fault
occurs, please call Customer Service.
(See list of Customer Service
representatives).
When you call, please quote the following:
Setting the saturation indicator
If it becomes necessary to change the
operating mode (exhaust-air/recirculating
mode), the saturation indicator for the filters
must also be altered (see Installation
Instructions).
E-Nr. FD
Enter the relevant numbers into the box
above. The E-Nr. (product no.) and FD
(production date) are shown on the
nameplate which can be seen inside the
extractor hood after the filter frame has
been detached.
Summary of Contents for D7980 Series
Page 94: ...94 Notizen ...
Page 95: ...95 351210 Z5114X5 Z5861N0 1 2 3 4 5 6 2x 10x 2x ...