NEFF D8642N0GB, Installation Instructions Manual

12

Installation

This extractor hood 

is intended to be

mounted onto the kitchen wall.

1.

Remove the grease filter (refer to 
Operating Instructions).

2.

Draw a line on the wall from the ceiling
to the lower edge of the hood at the
centre of the location where the hood is
going to be mounted.

3.

Using the template, mark positions on
the wall for the screws.

Ensure that the minimum distance bet-

ween the hob and the extractor hood is
maintained – 

550 mm

for an electric hob

and 

650 mm 

for a gas hob. The bottom

edge of the template equates to the lower
edge of the extractor hood.

4.

Drill 4 x 

l

8 mm holes for the extractor

hood and 2 x 

l

8 mm holes for the

chimney panelling. Insert plugs into the
holes so that they are flush with the wall.

Note: 

Take into account any special

accessories that are going to be fitted.

5.

Attach the 2 enclosed spacers to the
fixing bracket for the flue duct panelling.
Attach the fixing bracket for the 
chimney panelling using two hexagon
head cap screws.

6.

Screw in the two upper hexagon head
cap screws leaving them extended by
approx. 5 mm.

7.

Attach the extractor hood to the 
screws.

ca.5mm

30

178

347

36,5

400

mind.550 Elektro
mind.650 Gas

216

334