en
Basic operation
8
7.9 Switching off the fan run-on, variant 2
and 3
▶
Press .
7.10 Switching on the AirFresh function
The AirFresh function switches on the ventilation sys-
tem for approx. five minutes per hour at fan setting 1.
▶
Press
.
a
appears on the display.
7.11 Switching on the NoiseReduction
function
1
The noise reduction function reduces the fan noise.
The function is possible in all fan settings, except in fan
setting .
▶
Press .
a
The NoiseReduction function remains active even
after the appliance is switched off.
7.12 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
▶
Press .
7.13 Switching off automatic mode
1
▶
Press .
a
The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a
Automatic mode runs for a maximum of four hours.
7.14 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡
Factory setting: 5
¡
Lowest setting: 0
¡
Highest setting: 9
7.15 Setting the sensor sensitivity
1
Requirement:
The appliance is switched on.
1.
Press and hold .
a
The setting is displayed after approx. one second.
2.
Press or to change the setting.
3.
Release to save the setting.
7.16 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶
Press .
7.17 Setting the brightness
▶
Press and hold until the required brightness is
reached.
7.18 Switching on Ambient Light
1
You can switch on the Ambient Light independently of
the ventilation system.
▶
Press .
7.19 Ambient Light
1
- Setting the brightness
▶
Press and hold until the required brightness is
reached.
7.20 Ambient Light
1
- adjusting the colour
Requirement:
The appliance is switched off.
1.
Press .
2.
Press or repeatedly until the required colour is
set.
7.21 Setting the intermediate position for
the filter cover
On some appliances, the filter cover can be adjusted to
an intermediate position. The intermediate position can
be used to eliminate particularly strong cooking smells
and large amounts of steam.
▶
Take hold of the filter cover in the centre and open it
carefully.
7.22 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
7.23 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡
After the appliance has been switched off, ap-
pears on the display for the grease filter.
¡
After the appliance has been switched off, ap-
pears on the display for the odour filter.
▶
Press .
a
The saturation indicator is reset.
7.24 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement:
The appliance is switched on.
1.
Press and hold .
1
Depending on the appliance specifications
Summary of Contents for D95FQ Series
Page 19: ......
