15
Keeping the appliance clean
To avoid getting the cooking compartment dirty,
■
clean the cooking compartment after each use, as dirt will
bake on the next time it is heated up, and this can only be
removed with difficulty
■
always remove flecks of limescale, grease, starch and
albumin (e.g. egg white) immediately
■
Use the universal pan to bake very moist cakes
■
use suitable ovenware when roasting (e.g. roasting dish) or a
roasting sheet (see section: Accessories)
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
:
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
:
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after
sales service.
Removing the appliance door
1.
Open the appliance door fully.
2.
Open the locking levers on the left and right-hand side fully.
The hinges are secured and cannot snap closed.
3.
Close the appliance door until resistance becomes
noticeable (figure A)
4.
With both hands, grip the door on the left and right-hand side,
close the door a little more and pull it out (figure B).
Fitting the appliance door
1.
Insert the hinges in the left and right-hand holders (figure C).
The notch on both hinges must engage.
2.
Open the appliance door fully.
3.
Close the locking levers on the left and right-hand side fully
(figure D).
The appliance door is secured and can no longer be
removed.
4.
Close the appliance door.
Cleaning the door panels
To assist with cleaning, the inner door panel can be removed
from the appliance door.
:
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
:
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note:
Before removing, make a note of which way round the
door panel is fitted, so that it is not refitted the wrong way
round.
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and fitting the appliance door).
2.
Pull off the cover at the top of the appliance door. Press in
the tabs on the left and right using your fingers (fig. A).
Appliance part
Cleaning agent/aid
Enamel surfaces
To facilitate cleaning, you can switch on the interior lighting and detach the appliance
door if necessary.
Apply commercially available washing-up liquid or a vinegar solution with a soft, damp
cloth or chamois; dry with a soft cloth.
Loosen baked-on food residues with a damp cloth and detergent.
We recommend using oven cleaner if the oven is very dirty. When cleaning using an
oven cleaner, check the instructions of the manufacturer.
Leave the cooking compartment open to dry after cleaning.
Door seal
Hot soapy water
Hook-in rack/telescopic shelf
Hot soapy water
Accessories
Soak in hot soapy water, clean with a brush and sponge or wash in the dishwasher.
$
%
&
'
