16
3.
Lift the door panel and pull it out (figure B).
Cleaning
Clean the door panel with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Fitting the door panel
1.
Insert the door panel at an angle towards the back into both
brackets as far as it will go. The smooth surface must face
outwards.
2.
Put the cover back in place and press on it until it clicks in
place.
3.
Refit the appliance door.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
Faults and repairs
It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
:
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
%
$
$
%
D
D
&
'
Problem
Possible cause
Remedial action
Electrical function is faulty (e.g. indicator
lamps do not light up)
Circuit-breaker faulty
Check circuit-breakers in the fuse box and
replace if necessary
Liquid or thin dough runs to one side
Appliance not installed level
Check the appliance installation (see the
Installation instructions)
Smoke is generated during roasting or grill-
ing
Fat is burning on the grill element
Continue grilling or roasting until the fat on
the grill element is burnt away
Wire rack or universal pan inserted incor-
rectly
Check the shelf levels (see section: Roast-
ing or Grilling)
Higher levels of condensation are gener-
ated in the cooking compartment
Normal occurrence (e.g. when baking
cakes with very moist toppings or roasting
a large joint)
Open the appliance door briefly from time
to time during operation
