Operating the appliance
en
5
1
Operating the appliance
Operating
the appl
iance
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
Note:
Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel model 1
Setting the fan
Switching on
■
Touch the
#
symbol.
The fan starts at setting
ƒ
.
■
Touch + or - to alter the fan speed.
Switching off
Touch the
#
symbol.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Touch the
˜
symbol.
˜ƒ
appears on the display. Touch
the - symbol to switch back to the
˜‚
intensive setting.
After approximately six minutes, the electronics
automatically reduce the fan to a lower setting . If you
want to end the intensive setting before the preset time
expires, touch the
˜
symbol.
Fan run-on time
Touch the
9
symbol.
After approximately 10 minutes, the fan switches off
automatically.
AirFresh function
Touch the
3
symbol until the
‚
3
appears. The
fan runs for approximately five minutes per hour.
Touch the
3
symbol if you want to end the AirFresh
function.
Noise reduction function
The noise reduction function reduces the fan noise.
Switching on
Touch the
4
symbol.
This function is possible at all fan settings except fan
setting
‚
. This function also remains active after the fan
is switched off.
Switching off
Touch the
4
symbol.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
6
symbol.
Setting the brightness
Press and hold the
6
symbol until the required
brightness is reached.
Saturation display
When the metal grease filters or the activated charcoal
filter are/is saturated, an audible signal sounds for
approximately four seconds after the fan is switched off.
The following symbols also appear on the display:
”ªª
(metal grease filter) or
’ªª
(activated charcoal filter).
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
changed.
For instructions on how to clean the metal grease filters,
please refer to the section:
Cleaning and maintenance
.
The saturation indicator can be reset while it is flashing.
To do this, touch the - symbol.
Explanation
#
Fan on/off
4
Noise reduction
3
AirFresh function
-
Reduces the fan settings
+
Increases the fan settings/intensive setting 1, 2
˜
Direct selection of intensive setting 2
9
Fan run-on
6
Light on/off/dimming
