12
Changing the bulbs
Changing the filament bulbs
1.
Detach the bulb cover.
2.
Replace the defective bulb with a new one
of the same type and equivalent power (see
rating plate).
3.
Reinsert the bulb cover.
4.
Restore the power supply by inserting the
mains plug or switching on the fuse.
NOTE
:
If the light does not function, check
whether the bulbs have been inserted
correctly.
Defective bulbs should be replaced
immediately to avoid overloading the
remaining bulbs.
Before changing the bulbs, always follow
the instructions and warnings in the chapter
entitled ”Safety instructions”!
The description of changing the bulbs
applies to several appliance models.
NOTE
:
Observe the warranty regulations in
the enclosed service booklet.
Changing the halogen bulbs
Halogen bulbs become very hot during
operation. Even some time after the appliance
has been switched off, there is still a risk of
burns!
Before changing the halogen bulbs, ensure
that they have cooled down fully.
1.
Carefully remove the bulb ring with a
suitable tool.
2.
Replace the defective bulb with a new one
of the same type and equivalent power (see
rating plate).
NOTE
:
When inserting halogen bulbs, do not
touch the glass tube. Therefore use a clean
cloth when inserting the bulb.
3.
Reinsert the bulb cover.
4.
Restore the power supply by inserting the
mains plug or switching on the fuse.
Summary of Contents for I89E34N0GB
