NEFF I92CM67N0, Instruction Manual

6

Operating the appliance

These instructions apply to several appliance variants. It is 

possible that individual features are described which do not 

apply to your appliance.

Note: 

Switch on the extractor hood when you start cooking and 

switch it off again several minutes after you have finished 

cooking. This is the most effective way of removing the kitchen 

fumes.

Remote control

LED status bar

Setting the fan

Switching on

1.

Press the 

@

 button.

The fan starts at fan level 2.

2.

Press the 

@

 or

 A

 button to set a different fan level.

The set fan level is displayed in the LED status bar.

Switching off

Press the 

A

 button until the appliance switches off.

Intensive setting

You can use the intensive setting if there is a large build-up of 

odours and fumes/vapours.
Press the 

@

 button.

˜

 flashes in the LED status bar.

Note: 

The run time of the intensive mode is 4 minutes. Once 

this time has elapsed, the appliance switches back to fan level 

2.

Interval ventilation

With interval ventilation, the ventilation system switches on 

automatically at the set level for 10 minutes every hour.

1.

Switch off the appliance.

Notes

■

Press the 

A

 button until the appliance switches off.

■

or

 press the 

8

 button.

2.

Press the 

8

 button.

3.

Set the fan level.

Note: 

The interval ventilation is only activatable in fan levels 

1-3.

4.

Press the 

8

 button.

The set fan level and 

8

 flash in the LED status bar.

Fan run-on

With fan run-on, the appliance switches off automatically after 

10 minutes.
Press the 

9

 button.

The set fan level and 

9

 light up in the LED status bar.

Note: 

The fan run-on is only activatable in fan levels 1-3.

Lighting

Switching on

The lighting can be switched on and off independently of the 

ventilation system.
Press the 

6

 button.

Switching off

Press the 

6

 button.

Setting the brightness

Press and hold the 

6

 button until the desired brightness is 

reached.

Saturation indicator

If the filters are saturated, the following symbols flash:

■

Metal grease filters

: 1,2 and 

7

.

■

Activated charcoal filters

: 3,

˜

 and 

7

.

If you have not yet done so, perform the following steps now: 

■

Clean the metal grease filters or replace the activated 

charcoal filters; see section 

Cleaning and maintenance

 or the 

'CleanAir air recirculation module' printed supplement.

■

Reset the saturation indicator; see section 

Cleaning and 

maintenance

.

Resetting the saturation indicator

Press the 

9

 button.

An audible signal sounds for 3 seconds.

Note: 

The appliance switches off the saturation signal 

automatically after 20 hours.

Explanation

6

Light on/off/dimming

@

Increase fan level

A

Reduce fan level

8

Interval ventilation

9

Fan run-on

Explanation

1

Fan level 1

2

Fan level 2

3

Fan level 3

˜

Intensive mode

8

Interval ventilation

9

Fan run-on

7

Saturation indicator