en
12
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Possible cause
Remedial action
The light does not
work.
The bulb is defective.
Replace bulb. Fig.
,
/B
1. Switch the appliance off.
2. Pull out mains plug or switch off
fuse.
3. Slide cover forwards and remove.
4. Change the bulb.
(Replacement bulb:
220-240 V a.c., E14 bulb holder,
see defective bulb for wattage.)
Light switch is
jammed.
Check whether the light switch can
move. Fig.
,
/A
Floor of
the refrigerator
compartment is wet.
The condensation
channels or drainage
hole are blocked.
Clean the condensation channels
and the drainage hole. See chapter
Cleaning the appliance. Fig.
*
The temperature in
the refrigerator
compartment is too
cold.
Temperature controller
has been set too high.
Set temperature controller lower.
Appliance has no
refrigeration capacity.
The temperature
controller is in position
“0”.
Turn the temperature controller from
position “0”. Fig.
2
/A
■
Power failure.
■
The fuse has been
switched off.
■
The mains plug has
not been inserted
properly.
Check whether the power is on,
check the fuses.
