en
Installation and connection
26
--------
Before using your appliance
for the first time
1.
Remove leaflets, adhesive tape and
protective film.
2.
Clean the appliance.
Electrical connection
Caution!
Do not connect the appliance to
electronic energy saver plugs.
Note:
You can connect the appliance
to mains-controlled and sine-controlled
inverters.
Mains-controlled inverters are used for
photovoltaic systems which are
connected directly to the national grid.
Sine-controlled inverters must be used
for isolated applications. Isolated
applications, e.g. on ships or in
mountain lodges, which are not
connected directly to the national grid.
1.
After installing the appliance, wait at
least 1 hour before connecting it to
prevent damaging the compressor.
2.
Connect the appliance via a
correctly installed socket.
The socket must comply with the
following data:
Outside Europe: Check whether the
indicated current type of the
appliance corresponds with the
values of your power supply.
Appliance specifications are on the
rating plate.
"Getting to know your appliance"
3.
Connect the appliance to a socket
near the appliance.
The socket must be freely
accessible even after the appliance
has been installed.
Defrost the freezer compartment regularly.
A layer of hoarfrost or ice in the freezer
compartment impairs refrigeration of the
frozen food and increases power consumption.
Close the freezer compartment door properly.
The freezer compartment will become covered
in thick ice. If greater demands are made of the
appliance, the power consumption will increase.
Using the appliance
Socket with
220 V ... 240 V
Conductor
50 Hz
Fuse
10 A ... 16 A
