en
Faults – what to do?
36
3
Faults – what to do?
Faults –
what to d
o?
Before you call customer service, use this table to check whether you can rectify
the fault yourself.
--------
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
"Switching off and disconnecting the appliance"
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Displays do not illuminate.
The mains plug has not been inserted properly.
Connect the mains plug.
The fuse has tripped.
Check the fuses.
The power has failed.
Check whether the power is on.
Display indicates “E…”.
Electronics have detected a fault.
Call the customer service.
Appliance is not cooling, display and light are lit.
Demo mode switched on.
Hold down button
Alarm
for 10 seconds until an
acknowledgement signal sounds. Wait and check
whether the appliance is cooling.
