en
31
Defrosting
Refrigerator and “cool-fresh”
compartments
While the appliance is running,
condensation droplets or frost form on
the rear panel of the refrigerator
compartment. As the rear panel defrosts
automatically, it is not necessary to
remove the frost or the condensation
droplets. The condensation runs through
the condensation channel and the
drainage hole to the evaporation pan
where it evaporates.
Note
Keep the condensation channel
and drainage hole clean, so
the condensation can drain off. Fig.
*
Cleaning the appliance
m
Caution
■
Do not use abrasive, chloride or acidic
cleaning agents or solvents.
■
Do not use scouring or abrasive
sponges. The metallic surfaces could
corrode.
■
Never clean shelves and containers
in the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out mains plug or switch off fuse.
3. Take out the food and store in a cool
location. Place ice pack (if available)
on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light or through
the drainage hole into the evaporation
pan.
6. Wipe the door seal with clear water
only and then wipe dry thoroughly.
7. After cleaning reconnect and switch
the appliance back on.
8. Put the food back into the appliance.
Notes
■
Regularly clean the condensation
channel and drainage hole, Fig.
*
/B,
with a cotton bud to ensure that
the condensation can drain. The water
conduction channel, Fig.
*
/A, can be
taken out for cleaning.
■
After cleaning, the stopper must be re-
inserted into the drainage hole
of the refrigerator compartment for
functional reasons.
Summary of Contents for K8315 Series
