en
Faults – what to do?
40
3
Faults – what to do?
Faults –
what to d
o?
Before you call customer service, use this table to check whether you can rectify the
fault yourself.
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
"Switching off and disconnecting the appliance"
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Displays do not illuminate.
The mains plug has not been inserted properly.
Connect the mains plug.
The fuse has tripped.
Check the fuses.
The power has failed.
Check whether the power is on.
Display indicates “E…”.
Electronics have detected a fault.
Call the customer service.
A warning signal sounds and the Alarm button is lit.
Press the
Alarm
button. Alarm is switched off.
Appliance door is open.
Close the appliance door.
Ventilation openings have been covered.
Clear ventilation openings.
Large quantities of fresh food were placed in the
appliance.
Do not exceed max. freezing capacity.
Display flashes, warning signal sounds and button Alarm is lit.
Press the
Alarm
button. Alarm is switched off.
Appliance door is open.
Close the appliance door.
Ventilation openings have been covered.
Clear ventilation openings.
Large quantities of fresh food were placed in the
appliance.
Do not exceed max. freezing capacity.
Summary of Contents for KI6863D30
