en
Faults – what to do?
40
--------
Displays do not illuminate.
The mains plug has not been inserted properly.
Connect the mains plug.
The fuse has tripped.
Check the fuses.
The power has failed.
Check whether the power is on.
Display indicates “E…”.
Electronics have detected a fault.
Call the after-sales service.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
Start the appliance self-test.
"Appliance self-test" on page 41
When the programme has ended, the appliance
switches over to normal operation.
The cool-fresh compartment is too warm or too cold.
The standard setting was set too high or too low
(e.g. frost in cool-fresh compartment).
You can set the temperature in the cool-fresh com-
partment 3 settings warmer or colder. If the temper-
ature in the refrigerator compartment is set to the
setting 0, the cool-fresh compartment will have a
temperature close to 0 °C.
Note:
Any change to the standard setting will affect
the temperature in the refrigerator compartment and
freezer compartment.
1.
Press and hold the freezer compartment
Super
button until the display temperature
refrigerator compartment flashes.
2.
Press the
K
/
J
button to change the setting.
Setting –3 corresponds to the coldest setting.
S3 corresponds to the warmest setting.
The selected setting is saved after one minute.
Summary of Contents for KI842 Series
Page 111: ...2 h X P H C h e e s e 3 C C Alarm Super Super Alarm...
Page 112: ...1 2...
Page 113: ...1 3 2 1 2 3...
Page 114: ...2 3 4 3 1 4 2 1...
