20
Installating the switchbox
WARNING
The appliance may be installed with a
high cabinet or a high wall only on one
side of it. On the respective opposite
side, the height of an adjacent piece of
furnishing may not exceed the height of
the working surface in which the hob is
installed. The distance between the
high wall on the side of the hob and the
rear wall must comply with the
assembly instructions for the built-in
hob. Observe the protection class for
heat exposure as stated in the
assembly instructions
Installation
The worktop must already have a
cutout for the built-in hob (see built-in
hob installation instructions).
The switchbox must be installed before
the hob.
1.
Cut an opening in the wooden front
(max. 88
+2
mm x 525
+2
mm). (For
cutout dimensions of worktop, see
installation instructions for hob).
2.
Prior to installation:
Mark the centre of the cutout.
Align the support with the notch and
screw on flush with the front edge of
the facia.
3.
Insert appliance:
Push the appliance in carefully so
that no cables can become caught.
4.
Check functioning.
Important when disassembling:
Deenergize the appliance. Undo the
earthed conductor from the earthing
screw.
Remove hob or intermediate base and
push out the switchbox from the back.
43
88
+2
525
+2
56
7
260
100
max. R 8
Summary of Contents for L1542N0
