Installation instructions
en
19
Fitting tilt protection
Suitable tilt protection (order number: 12039458) can
be obtained from customer service, on our website or
in the online shop.
1.
Measure a clearance of 518 mm from the front
edge of the unit and mark it on both sides in the fit-
ted unit.
2.
Screw the two brackets into the elongated hole on
the mark.
3.
Place the appliance on a flat surface.
4.
Unscrew the two lower screws on the back of the
appliance.
5.
Use the two screws to tighten the two metal retain-
ers on the back of the appliance.
‒
Ensure that the metal retainers are aligned ex-
actly with the edge of the appliance.
6.
Slide the appliance into the fitted unit and check
whether the tilt protection engages.
7.
If required, correct the position of the bracket with
the elongated hole.
8.
Finally, screw the brackets to the fitted unit.
9.
Insert the power cable fully into the appliance.
10.
Push the appliance into the fitted unit.
‒
Do not pinch the power cable.
Summary of Contents for N 9HA11 Series
Page 1: ...Warming drawer User manual and installation instructions N 9HA11...
Page 22: ......
Page 23: ......
