en
Installation instructions
20
11.
Remove the adhesive strip from the appliance front.
12.
Open the appliance carefully and check whether the
tilt protection is working.
Installing the appliance
WARNING ‒ Risk of injury!
When the door is opened, the appliance may tip over.
▶
In the case of installation without an intermediate
floor, weigh down the appliance with a suitable
weight before opening.
1.
Insert the power cable fully into the appliance.
2.
Push the appliance all the way into the fitted unit.
‒
Do not pinch the power cable.
3.
Centre the appliance.
4.
Remove the adhesive strip from the appliance front.
5.
Open the appliance.
6.
Screw the appliance to the fitted unit.
7.
Insert the power cable into a protective contact
socket.
The power cable must not touch the rear and base
of the appliance after installation.
Inserting the design profiles
1.
Fold together the fastening elements.
2.
Hook the fastening elements into the openings at
the bottom and push down until they engage.
Insert the red fastening elements into the upper
opening.
Insert the green fastening elements into the lower
opening.
3.
Remove the protective film from the design profiles.
4.
Insert the design profiles on both sides of the appli-
ance.
5.
Check the clearances of the design profiles.
Adjusting design profiles
WARNING ‒ Risk of injury!
Parts that are accessible during installation may have
sharp edges and may lead to cutting injuries.
▶
Wear protective gloves.
ATTENTION!
Unsuitable tools may damage the surface of the appli-
ance.
▶
Only use plastic tools.
▶
Do not use pointed or sharp tools.
1.
Pull the design profiles forwards to remove them. If
necessary, carefully loosen and remove the design
profiles using a plastic tool.
Summary of Contents for N 9HA11 Series
Page 1: ...Warming drawer User manual and installation instructions N 9HA11...
Page 22: ......
Page 23: ......
