NEFF N5 D4 Series, Instruction Manual

en

    Operating the appliance

10

Residual heat indicator

The hob has a residual heat indicator for each hotplate. 

This indicates that a hotplate is still hot. Do not touch a 

hotplate while the residual heat indicator is lit up.
The following indicators are shown depending on the 

amount of residual heat:

■

Display 

 •

: High temperature

■

Display 

 œ

: Low temperature

If you remove the cookware from the hotplate during 

cooking, the residual heat indicator and the selected 

heat setting will flash alternately.
When the hotplate is switched off, the residual heat 

indicator will light up. Even after the hob has been 

switched off, the residual heat indicator will stay lit for as 

long as the hotplate is still warm.

1

Operating the appliance

Operating the appliance

This chapter explains how to set a hotplate. The table 

shows heat settings and cooking times for various 

meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: Touch the 

#

 symbol. An audible signal 

sounds. The indicator next to the main switch and the 

hotplate indicators 

‹

 light up. The hob is ready to use.

To switch off: Touch the 

#

 symbol until the indicator 

goes out. All hotplates are switched off. The residual 

heat indicator remains lit until the hotplates have cooled 

down sufficiently.

Notes

■

The hob switches off automatically if all hotplates 

have been switched off for more than 20 seconds.

■

The selected settings are stored for four seconds 

after the hob has been switched off. If you switch it 

on again during this time, the hob will operate using 

the previously stored settings.

Setting a hotplate

Use the 

@

 and 

A

 symbols to select the required heat 

setting. 
Heat setting 

‚

 = lowest setting.

Heat setting 

Š

 = highest setting.

Every heat setting has an intermediate setting. This is 

marked with a dot.

Notes

■

To protect the fragile parts of your appliance from 

overheating and electrical overloading, the hob may 

temporarily reduce the power.

■

In order to prevent the appliance from producing 

excess noise, the hob may temporarily reduce the 

power.

Selecting a hotplate and heat setting

The hob must be switched on.

1.

Select the required hotplate by touching the 

Ò

 or 

Ó

symbol.

The 

Ø

 indicator lights up.

2.

Touch the 

@

 or 

A

 symbol within 10 seconds. The 

following basic setting appears:

@

 symbol: 

Š

 heat setting

A

 symbol: 

…

 heat setting

The heat setting is set.