en
20
If in doubt, please contact the detergent
manufacturer, especially if:
the utensils are very wet at the end
of the programme.
limescale forms.
Note
Optimum rinsing and drying results can be
obtained by using standard detergents in
conjunction with separate application of
salt and rinse aid.
Observance of the operating instructions
or information on the packaging of the
combined detergents determines their
effectiveness.
If the “Add rinse aid or special salt” display
is defective, you can switch it off as
follows:
Switching “Add rinse aid”
off and on:
Switch on the appliance with the main
switch
1
.
Keep pressing button M/OK
2
until
the “rinse aid 4” setting is displayed.
By pressing buttons – or +
3
,
you can select a set value between
0 and 6. To switch off, select position “0”
Press button M/OK
2
. The set value
is saved and you are returned to the
Start menu.
If the set value “0” is selected, rinse aid
is not dispensed. Low rinse aid is not
displayed.
Switching “Add special salt”
and therefore the water
softening system off and on:
Switch on the appliance with the main
switch
1
.
Keep pressing button M/OK
2
until
the “hardness auto” setting is displayed.
By pressing buttons – or +
3
,
select a set value between 0 (off) and 7.
The factory setting is “hardness auto”.
To switch off, select position “0”
Press button M/OK
2
. The set value
is saved and you are returned to the
Start menu.
If the set value “0” (off) is selected, the
water softening system is switched off.
Low salt is not displayed.
Note
If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid dispenser amount
has been switched on and the water
softening system has been set to the
correct water hardness or to “hardness
auto”.
