en
27
Cancel Programme
In order to interrupt the programme,
open the door. In order to avoid water
escaping, only open the door slightly
first.
The message “Cancel Programme”
will be displayed, alternating with
the message “Close the door”,
the remaining programme time, the
selected programme, and the current
programme phase.
In order to interrupt, do not in any
circumstance press the button –
3
“Cancel Programme” because this will not
allow the programme to continue!
To continue the programme, close the
door. The programme will continue
automatically.
In the case of a warm water supply or
when the appliance is already heated,
leave the door slightly ajar for a few
minutes before closing it. Otherwise the
door can spring open again due to the
warm air trapped in the device’s interior.
Cancelling active programme
Open the door. First open the door only
slightly in order to avoid water spraying
out.
The message “Cancel Programme” will
be displayed, alternating with the
message “Close the door”, the
remaining programme time, the
selected programme, and the current
programme phase.
In order to cancel the programme,
press –
3
“Cancel Programme”.
The display shows “To drain Close
the door” with the message “Close the
door” flashing.
Close the door. The water remaining in
the device’s interior will be pumped off.
Once the pumping off has finished
a buzzer will sound 5 times.
Open the door. “Ready” is briefly
displayed, the appliance automatically
switches off after 5 seconds.
End of the programme
As soon as the programme has finished
a buzzer will sound 5 times.
Open the door. “Ready” is briefly
displayed, the appliance automatically
switches off after 5 seconds.
If the door is not opened, the appliance
automatically switches off after one
hour. During this time the acoustic
signal sounds every 15 minutes.
After letting the device cool down take
out the dishes.
When the programme has finished you
can switch off the appliance or start it
again.
Note
For an optimum drying of the dishes wait
for 15 minutes after the programme has
finished before you open the door and
empty the dishwasher. During this time the
possibly remaining water on the dishes
can evaporate and condense on the sides
of the device’s interior.
Note
If the device becomes disconnected from
the power supply during operation (e.g.
it is switched off or there is a power cut),
all settings remain stored. Operation will
resume automatically once the power
supply has been restored.
