en
Fault, what to do?
48
The Machine Care display
lights up. *
Machine Care is recommended.
Run the Machine Care programme using a
special dishwasher cleaning agent and
without loading any utensils.
The display will go out automatically after
three wash cycles whether or not the
Machine Care programme is carried out.
Water is left in the
appliance at the end of the
programme.
Filter system or area under the
filters
1j
is blocked.
Clean filters and area underneath.
Program has not ended yet.
Wait until programme ends or reset.
Utensils not dry.
No or too little rinse aid in the
dispenser.
Refill rinse aid.
Programme selected without
drying.
Select programme with drying.
Water collecting in depressions
on the utensils and cutlery.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
The combined detergent used
has a poor drying performance
Use different combination detergent with
better drying performance. Use of rinse
aid also increases the drying performance.
extraDry to increase drying not
activated.
Activate extraDry.
Utensils were removed too early
or drying process had not ended
yet.
Wait until program ends or wait until 30
min after program ends before removing
utensils.
The eco rinse aid used has a
limited drying performance.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic utensils not dry.
Special properties of plastic.
Plastic has a lower heat storage capacity
and therefore dries less well.
Cutlery not dry.
Cutlery not arranged properly in
the cutlery basket.
Separate cutlery if possible, prevent
contact points.
Cutlery not arranged properly in
the cutlery drawer.
Arrange cutlery properly and separate if
possible.
Fault
Cause
Remedial action
* depending on the configuration of your specific dishwasher
Summary of Contents for S517T80D6E
Page 1: ...en Instruction manual Dishwasher S...
Page 2: ...5HVHW VHF 6HWXS VHF...
