Installation and connection
en
35
5
Installation and
connection
Installation and connection
The dishwasher must be connected
correctly, otherwise it will not function
properly. The specifications for the inlet
and outlet as well as the electrical
connected loads must correspond with
the required criteria as
specified in the following paragraphs
or in the installation instructions.
Install the appliance in the correct
sequence:
1.
Checking appliance on delivery
2.
Installing the appliance
3.
Waste water connection
4.
Fresh water connection
5.
Electrical connection
Product package
If you have any complaints, contact
the dealer where you purchased
the appliance or our customer service.
ヽ
Dishwasher
ヽ
Instructions for use
ヽ
Installation instructions
ヽ
Warranty*
ヽ
Installation materials
ヽ
Steam guard plate*
ヽ
Rubber apron*
ヽ
Power cord
* depending on model
Safety instructions
Please follow the safety instructions
under “Installation”.
Delivery
Your dishwasher has been checked
thoroughly in the factory to ensure that it
is in working order. This may cause
small water stains. These will disappear
after the first wash cycle.
Technical specifications
Weight:
max. 60 kg
Voltage:
220–240 V, 50 Hz or 60 Hz
Connected load:
2.0–2.4 kW
Fuse:
10/16 A (UK 13A)
Power input:
switched off 0.5 W
not switched off 0.5 W
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water; hot water max. temperature
60 °C.
Summary of Contents for S51T69X3GB
Page 1: ...HQ 23 5 7 1 16758 7 216 Q 6 6 5...
Page 2: ...K 6WDUW K K PLQ 5HVHW VHF...