NEFF T..D82 series, Instruction Manual

26

Accessing the basic settings

The hob must be switched off.

1.

Switch on the hob.

2.

Within the next 10 seconds, touch and hold the 

"

 symbol for 

4 seconds.

™

 and 

‚

 flash alternately in the displays and 

‹

 appears as a 

preset.

3.

Touch the 

"

 symbol repeatedly until the required function is 

displayed. 

4.

Then select the required setting with the 

+

 and 

-

 symbols.

5.

Touch and hold the 

"

 symbol again for 4 seconds.

The settings have been saved.

Quit

To leave the basic settings, turn off the hob at the main switch.

Care and cleaning

The advice and warnings contained in this section aim to guide 

you in cleaning and maintaining the hob, so that it is kept in the 

best possible condition

Hob

Cleaning

Clean the hob after each use. This prevents food remains left 

on the surface from burning. Wait until the hob is cool enough 

before attempting to clean it.
Only use cleaning products specifically designed for hobs. 

Follow the instructions provided on the packaging.
Do not use:

■

Undiluted washing-up liquid

■

Dishwasher detergent

■

Abrasive products 

■

Corrosive products such as oven sprays or stain removers

■

Sponges that may scratch 

■

High-pressure or steam cleaners

The best way to remove stubborn stains is to use a glass 

scraper. Follow the manufacturer's instructions.
Suitable glass scrapers can be obtained through the Technical 

Assistance Service or from our online shop.

Hob frame

In order to avoid damage to the hob frame, follow the 

indications below:

■

Use only slightly soapy hot water

■

Do not use sharp or abrasive products

■

Do not use a glass scraper

Fixing malfunctions

Malfunctions are usually due to small details. Before calling the 

Technical Assistance Service you should bear in mind the 

following advice and warnings.

Indicator

Malfunction

Solution

none

The electric power supply has been cut off. 

Use other electrical appliances to check whether there 

has been a power cut. 

The appliance has not been correctly con-

nected following the connection diagram.

Check that the appliance has been connected cor-

rectly according to the connection diagram.

Electronic system malfunction.

If none of the above checks resolve the malfunction, 

contact the Technical Assistance Service.

The indicators flash

The control panel is damp or an object is rest-

ing on it.

Dry the control panel area or remove the object.

The indicator 

-

 flashes on 

the hotplate indicators

A fault has occurred in the electronic system. Briefly cover the control panel with your hand to con-

firm the malfunction.

* If the warning persists call the Technical Assistance Service.

Do not rest hot pans on the control panel.