21
Residual heat indicator
The hob has a residual heat indicator for each hotplate to show
those which are still hot. Avoid touching a hotplate that displays
this.
Even when switched off, the
œ
/
•
light will remain on as long as
the hotplate remains hot.
If the pan is removed before the hotplate is turned off the
œ
/
•
indicators and the selected power level will appear alternately.
Twistpad and twist knob
The twistpad is the area in which you can use the twist knob to
select the hotplates and set heat settings. The twist knob
automatically centres itself in the twistpad area.
The twist knob is magnetic and is placed on the twistpad.
Tapping the twist knob where there is a marking activates the
relevant hotplate. Turning the twist knob sets the heat setting.
After positioning the twist knob, it may not be centred correctly
on the twistpad. The twist knob can be centred again by
moving it gently.
Note:
The alignment does not affect the function of the twist
knob.
Removing the Tipp control
When the Tipp control is removed, the cleaning lock function is
activated.
The Tipp control can be removed when the hotplates are on.
The cleaning lock function is activated for 35 seconds. If after
the time has elapsed, the Tipp control is not returned to its
position, the cooker switches off.
:
Risk of fire!
If a metal object is placed on the Tipp-Pad zone during these
35 seconds, the hob may continue to heat. Therefore, always
turn off the hob using the main switch.
Storing the twist knob
A strong magnet is located inside of the twist knob. Keep the
twist knob away from magnetic data carriers, such as video
cassettes, diskettes, credit cards and cards with magnetic
strips. Otherwise, these data carriers may be damaged beyond
repair.
The twist knob can also cause interference in television sets
and monitors.
Note:
The twist knob is magnetic. Metal particles which stick to
the underside can scratch the hob. Always wipe the twist knob
thoroughly.
Emergency mode
The hob can also operate without the Tipp control:
1.
Switch on the hob using the main switch.
2.
Within the following 5 seconds, press the
–
and
3
symbols
simultaneously. A signal sounds.
3.
Press the
3
symbol until the indicator lights up on the
desired hotplate.
4.
Then press the
–
symbol to select the desired power level.
The hotplate is switched on.
Notes
■
The time program function cannot be activated in emergency
mode.
■
The Tipp control can be placed back on the hob at any time.
Programming the hob
This section will show you how to program the hotplates. The
table contains power levels and cooking times for several
dishes.
Switching the hotplate on and off
The range is turned on and off using the main switch.
To turn on: press the
#
symbol. The indicator above the main
switch lights up. The range is ready for use.
To turn off: press the
#
symbol until the indicator above the
main switch disappears. All hotplates are turned off. The
residual heat indicator stays lit until the hotplates have cooled
off sufficiently.
Notes
■
The range switches off automatically when all the hotplates
are switched off for more than 15 seconds.
■
The settings are memorised for 4 seconds after the range
has been turned off. If the hotplate is switched back on within
this time then the previous settings will be applied.
Setting the hotplate
Select the required cooking power using the Tipp control.
Power level 1 = minimum power.
Power level 9 = maximum power.
Each power level has an intermediate setting. This is marked
with a dot.
Setting the heat setting
The hob must be switched on.
1.
Select the hotplate. To do this, tap the twist knob in the
direction of the required hotplate.
Summary of Contents for T T 2 Series
Page 2: ...2 Ø cm T T 2 ...
