NEFF T26CS12 Series, Instruction Manual

en

    Gas burners

6

Accessories

Depending on the model, the hob may include the 

following accessories. These can also be acquired from 

the Technical Assistance Service.

--------

Code

The manufacturer accepts no liability if these 

accessories are not used or are used incorrectly.

Ä

Gas burners

Gas burners

Switching on manually

1.

Press the control knob for the selected burner and 

turn it anticlockwise to the highest power setting.

2.

Hold an igniter or a naked flame (such as a lighter or 

a match) against the burner.

Automatic ignition

If your appliance has automatic ignition (ignition plugs):

1.

Press the control knob for the selected burner and 

turn it anticlockwise to the highest power setting.

Sparks are produced on all burners while you are 

pressing and holding the control knob. The burner 

ignites.

2.

Release the control knob.

3.

Turn the control knob to the required position.

If the burner does not ignite, switch it off and repeat the 

steps described above. This time, hold the control knob 

down for longer (up to 10 seconds).

:

Warning – Risk of deflagration! 

If the burner does not switch on after 15 seconds, 

switch off the control knob and open the door or 

window in the room. Wait at least a minute before 

igniting the burner again.

Note: 

It is important to keep the appliance clean. If the 

ignition plugs are dirty, this may cause ignition faults. 

Clean the ignition plugs regularly with a small non-

metallic brush. Take care to prevent the ignition plugs 

from suffering any heavy knocks.

Safety system

Your hob is equipped with a safety system 

(thermocouple) that cuts off the gas when the burners 

are accidentally switched off.

To ensure that this device is active:

1.

Switch on the burner as usual.

2.

Without releasing the control knob, press and hold it 

down firmly for 4 seconds after lighting the flame.

Switching off a burner

Turn the corresponding control knob clockwise to the 0 

setting.
A few seconds after the burner is switched off, a sound 

(thud) will be produced. This is not a fault - this means 

that the safety device is no longer operating.

Warnings

It is normal to hear a soft whistling noise while the 

burner is operating.
When first used, it is normal for the burner to give off 

odours. This does not pose any risk and does not 

indicate a malfunction. They will disappear in time.

Additional wok grid

Only suitable for use on wok 

burners. Use cookware with a 

rounded base.
To extend the service life of the 

appliance, we recommend using 

the additional wok grid.

Additional espresso maker 

grid

Only suitable for use on the 

smallest burner. Use cookware 

with a diameter of less than 

12 cm.

Z2471X0 Additional wok grid: Cast iron (4-5 kW)
Z2402X0 Additional espresso maker grid