Operating modes
en
11
Ç
Operating modes
Operating modes
This appliance can be used in air extraction mode or
circulating-air mode.
Exhaust air mode
Note:
The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heat-producing appliances.
■
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
■
If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.
Air recirculation
Note:
To bind odours in air recirculation, you must
install an activated carbon filter. The different options for
operating the appliance in air recirculation can be found
in the brochure. Alternatively, ask your dealer. The
required accessories are available from specialist
retailers, from after-sales service or from the Online
Shop.
K
Before using for the first
time
Before using for the first time
Please read the following information before using the
appliance for the first time:
Clean the appliance and all accessory parts thoroughly.
Before you can use your new appliance, you must apply
certain settings.
Switch the hob on and off using the main switch
#
.
Setting the operating mode
The appliance is supplied with a preset air recirculation
mode.
When the hob is installed with an air outlet to the
outside, you must configure the setting
™‚ˆ
in this
mode. See section
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air that is drawn in is cleaned by the
grease filters and the activated carbon filter,
and conveyed back into the kitchen.
