Wipe protection
en
17
k
Wipe protection
Wipe protection
Wiping over the control panel while the hob is switched
on may alter the settings. To avoid doing this, you can
use the hob's "Lock control panel for cleaning" function.
To activate this function: Remove the twist knob. The
z
indicator will be lit.The control panel will remain
locked for 35 seconds. You will now be able to clean
the surface of the control panel without altering the
settings.
To deactivate this function: The control panel will be
unlocked once 35 seconds have elapsed. To end the
function early, fit the twist knob back on and turn it until
the
z
indicator goes out.
Notes
■
The timer displays the time that has elapsed since
the lock was activated. An audible signal sounds 30
seconds after activation. This indicates that the
function is about to finish.
■
The cleaning lock does not lock the main switch. The
hob can be switched off at any time.
b
Automatic safety cut-out
Automatic safety cut-out
If a hotplate operates for an extended period and no
settings are changed, the automatic safety shut-off is
activated.
The hotplate stops heating.
”
,
‰
and the residual heat
indicator
œ
or
•
flash alternately in the hotplate display.
When you touch any symbol, the display switches off.
The hotplate can now be set again.
The point at which the safety shut-off becomes active
depends on which heat setting has been set (after 1 to
10 hours).
