Hood connection
en
37
e
Hood connection
Hood connection
You can connect this appliance to a suitable extractor
hood and then control the functions of the hood via your
hob.
You have various options for connecting the appliances
together:
Home Connect
Two appliances can be connected using the Home
Connect app provided that both of them are Home
Connect-compatible.
Both appliances can be controlled via the app and via
the control panel.
Refer to the Home Connect documents supplied and
the Home Connect section for more information.
Connecting appliances directly
If the appliance is connected directly to an extractor
hood, the extractor hood can be controlled via the hob.
It is then not possible for either of the appliances to
connect to your home network or to the app. Both
appliances can be controlled via the control panel.
Connecting appliances via your home network
Use this type of connection if neither or one of the two
appliances is connected to the Home Connect app.
If the appliances are connected to each other via your
home network, you can use both the hood controls and
Home Connect to operate the hob.
Notes
■
Make sure you follow the safety instructions in the
instruction manual for your extractor hood and that
these are complied with even when operating the
appliance via the hood controls on the
"Important safety information" on page 6
■
If the appliance is being operated by means of the
controls on the extractor hood, this mode of
operation always has priority. It is not possible to use
the hood controls on the hob during this time.
■
In networked standby mode, your appliance requires
a maximum of 2 W.
Setting up
Both the hob and the extractor hood must be switched
on before you can connect them to each other.
To do this, refer to the section entitled "Connecting to
the hob" in the instruction manual for your extractor
hood.
Connecting directly
If you connect your hob directly to the extractor hood, it
cannot be connected to your home network as well and
you will not be able to use Home Connect.
1.
Switch on the hob.
2.
Touch and hold the
.
symbol for 3 seconds.
The product information is displayed.
3.
Touch the
.
symbol repeatedly until the
™‚‡
setting appears.
‹
lights up in the hotplate display.
4.
Set the value to
‚
using the twist knob.
‚
flashes in the hotplate display.
5.
You have two minutes to initiate the connection
process on the extractor hood.
Once the hob is connected to the extractor hood, the
value
„
appears in the hotplate display. After you exit
the settings menu, the symbols for the hob-based hood
controls are displayed in the hob's control panel.
