NEFF T58 T2 Series, Instruction Manual

Childproof lock    

en

19

A

Childproof lock

Childproof lock

You can use the childproof lock to prevent children 

from switching on the hob.

Activating and deactivating the childproof 

lock

The hob must be switched off.
To activate: Touch the 

.

 symbol for approx. 4 seconds. 

The 

‚

 indicator lights up for 10 seconds. The hob is 

locked.
To deactivate: Touch the 

.

 symbol for approx. 4 

seconds. The lock is released.

Childproof lock

With this function, the childproof lock automatically 

activates when a hob is switched off.

Switching on and off

You can find out how to switch the automatic childproof 

lock on in the 

~

 "Basic settings"

 section

k

Wipe protection

Wipe protection

Wiping over the control panel while the hob is switched 

on may alter the settings. To avoid doing this, you can 

use the hob's "Lock control panel for cleaning" function. 
To activate this function: Remove the twist knob. The 

 z

 indicator will be lit.The control panel will remain 

locked for 35 seconds. You will now be able to clean 

the surface of the control panel without altering the 

settings.
To deactivate this function: The control panel will be 

unlocked once 35 seconds have elapsed. To end the 

function early, fit the twist knob back on and turn it until 

the 

 z

 indicator goes out.

Notes

■

The timer displays the time that has elapsed since 

the lock was activated. An audible signal sounds 30 

seconds after activation. This indicates that the 

function is about to finish.

■

The cleaning lock does not lock the main switch. The 

hob can be switched off at any time.

b

Automatic safety cut-out

Automatic safety cut-out

If a hotplate operates for an extended period and no 

settings are changed, the automatic safety shut-off is 

activated.
The hotplate stops heating. 

”

, 

‰

 and the residual heat 

indicator 

œ

 or 

•

 flash alternately in the hotplate display.

When you touch any symbol, the display switches off. 

The hotplate can now be set again.
The point at which the safety shut-off becomes active 

depends on which heat setting has been set (after 1 to 

10 hours).