NEFF T58 T2 Series, Instruction Manual

Power manager    

en

23

h

Power manager

Power  manager

You can use the power manager to set the total power 

of the hob.
The hob is preset at the factory. Its maximum 

performance is specified on the rating plate. You can 

use the power manager to change the value in 

accordance with the requirements for the relevant 

electrical installation.
In order not to exceed this set value, the hob 

automatically distributes the power available between 

the cooking zones that are switched on.
As long as the power manager function is activated, the 

output of a cooking zone may temporarily fall below the 

nominal value. If a cooking zone is switched on and the 

power limit is reached, 

¬

 appears in the heat setting 

display for a short time. The appliance automatically 

regulates and selects the highest possible power level.
For more information about how the total power of the 

hob is changed, see section 

~

 "Basic settings"

D

Cleaning

Cleaning

Suitable maintenance and cleaning products can be 

purchased from the after-sales service or in our e-Shop.

Hob

Cleaning

Always clean the hob after cooking. This will prevent 

food deposits from becoming burned on. Only clean the 

hob after the residual heat indicator has gone out.
Clean the hob with a damp dish cloth and dry it with a 

cloth or towel to prevent limescale build-up.
Only use cleaning agents that are suitable for this type 

of hob. Observe the manufacturer's instructions on the 

product packaging.
Never use:

■

Undiluted washing-up liquid

■

Cleaning agents designed for dishwashers

■

Abrasive cleaners 

■

Harsh cleaning agents, such as oven spray and 

limescale remover

■

Scouring pads 

■

High-pressure cleaners or steam jet cleaners

Stubborn dirt is best removed with a glass scraper, 

available from retailers. Observe the manufacturer's 

instructions.
You can obtain a suitable glass scraper from customer 

services or through our online shop.
Using a special sponge for cleaning glass-ceramic 

hobs achieves a great cleaning result.

Note: 

Do not use any cleaning agents while the hob is 

still hot. This may mark the surface. Make sure that any 

residue left by cleaning agents is removed.

Hob surround

To prevent damage to the hob surround, observe the 

following instructions:

■

Only use warm soapy water

■

Wash new dish cloths thoroughly before use.

■

Do not use harsh or abrasive cleaning agents.

■

Do not use a glass scraper or sharp objects.

Twist knob

The twist knob is best cleaned using lukewarm soapy 

water. Do not use harsh or abrasive cleaning agents. 

Do not clean the twist knob in the dishwater or using 

rinsing water. This may damage it.

Potential marks

Limescale and water 

marks

Clean the hob as soon as it has cooled down. 

You can use a cleaning agent suitable for 

glass-ceramic hobs.*

Sugar, rice starch or 

plastic

Clean immediately. Use a glass scraper. Cau-

tion: Risk of burns.*

* Then clean with a damp dish cloth and dry with a cloth or towel.