NEFF T59 T6 Series, Instruction Manual

en

    Flex Zone

14

|

Flex Zone

Flex Zone

You can use the hob as a single hotplate or as two 

independent hotplates, as required.
It consists of four inductors that work independently of 

each other. If using the flexible cooking zone, only the 

area that is covered by cookware is activated.

Advice on using cookware

To ensure that the cookware is detected and heat is 

distributed evenly, correctly centre the cookware:

As two independent hotplates

The flexible cooking zone is used like two independent 

hotplates.

Activating

See section 

~

 "Operating the appliance"

As a single hotplate

Using the entire cooking zone by connecting both 

hotplates.

Linking the two hotplates

1.

Set down the cookware. Select one of the two 

hotplates in the flexible cooking zone and set the 

heat setting.

2.

Touch the 

{

 symbol. The 

u

 indicator lights up. 

The flexible cooking zone is activated.

Note: 

The heat setting appears in the two displays for 

the flexible cooking zone.

Changing the heat setting

Select one of the two hotplates assigned to the flexible 

cooking zone and set the heat setting using the twist 

knob.

Adding new cookware

Set the new item of cookware down, select one of the 

two hotplates in the flexible cooking zone and then 

touch the 

{

 symbol twice. The new cookware is 

detected and the previously selected heat setting 

remains the same.

Note: 

If the cookware is moved to the hotplate being 

used or lifted up, the hotplate begins an automatic 

search and the heat setting selected previously is 

retained.

Disconnecting the two hotplates

Select one of the two hotplates assigned to the flexible 

cooking zone and touch the 

{

 symbol.

This deactivates the flexible cooking zone. The two 

hotplates will now function independently.

Note: 

If the hotplate is switched off, and then switched 

back on again later, the flexible cooking zone is reset to 

function as two independent hotplates.

As a single hotplate

Diameter smaller than or equal to 13 cm 

Place the cookware on one of the four posi-

tions that can be seen in the illustration.

Diameter greater than 13 cm 

Place the cookware on one of the three 

positions that can be seen in the illustration.

If the cookware takes up more than one 

hotplate, place it starting on the upper or 

lower edge of the flexible cooking zone.

As two independent hotplates

The front and rear hotplates each have two induc-

tors and can be used independently of each other. 

Select the required heat setting for each of the 

hotplates. Use only one item of cookware on each 

hotplate.

Middle hotplate

Diameter smaller than or equal to 13 cm 

Place the cookware on one of the three positions 

that can be seen in the illustration.

Diameter greater than 13 cm 

Place the cookware on one of the two positions 

that can be seen in the illustration.

If the cookware occupies more than two induc-

tors, place it starting from the upper or the lower 

edge of the hotplate.

Recommendations

If the hob has more than one flexible 

cooking zone, place the cookware on 

top so that it covers only one of the flex-

ible cooking zones.
Otherwise, the hotplates will not be 

activated as intended and the cooking 

result will not be satisfactory.